Franke FDW 908 IB XS Manuel d'instructions

Instructions for use and installation Cooker Hood Istruzioni per l’uso e l’installazione Cappa Mode d’emploi et installation Hotte de Cuisine B

EN 110 Fixing the Squaring Brackets • Screw the brackets 7.3 to the Hood Canopy using the screws 12b provided, without tightening completely.

EN 111 AFixing the Motor Unit • Installation of the Motor Unit (1) at the front or rear must be de-cided according to the position of the

EN 112 Fixing the Electric Unit • Connect the Electric cables that come out of the lower right hand part of the Hood Canopy to the Connector

EN 113 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexibl

EN 114 Warning..: Handle with care Fitting the Front element • Lift the mobile hood canopy (see paragraph on Use) by just a few centimetres. •

EN 115 Surround Suction Panel • Open the Hood Door (see USE). • Remove the 2 strips of adhesive tape fastening the panel during transport

EN 116 USE Control panel Button Function LED button A The button only works when the door is open. Press Briefly = Turns the Lights On/Off

EN 117 REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1.5 V carbon-zinc alkaline batteries of th

EN 118 MAINTENANCE Cleaning the Comfort Panels • Open the Comfort Panel by pulling it at the top. • Unhook the security chain by opening the

EN 119 Activated Charcoal Filter (Recirculation Version) Can be washed in the dishwasher. It must be washed when button “C” lights up or at lea

2 2 INDEX RECOMMENDATIONS AND SUGGESTIONS ...

991.0266.342_ver4 Franke S.p.a. Via Pignolini,2 37019 Peschiera del Garda (VR) www.franke.it

EN 3 3 RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descri

EN 4 4 CHARACTERISTICS Components Ref. Q.ty Product Components 1 1 Hood Canopy complete with: Controls, Light, Filters 2 1 Motor unit

EN 5 5 Dimensions This Cooker hood can be used in conjunction with a Gas Cook Top having the following characteristics: • Maximum power 12,4

EN 6 6 INSTALLATION This Hood is set up to be fitted inside the kitchen unit in: • Ducting version: Evacuation to the outside. • Recirculati

EN 7 7 7.212a7.212aAInserting the Hood Canopy into the support surface from below • The Hood is built ready for front installation of the Mo-

EN 8 8 7.212a7.212aInserting the Hood Canopy into the support surface from above • Insert the Brackets 7.2, as indi-cated in the figure, int

EN 9 9 12c12a7.112a7.1Fixing the Lower Brackets • Screw the brackets 7.1 to the front of the Hood Canopy using the screws 12a provided. • B